Differences

This shows you the differences between two versions of the page.

--- printer-setup [2021/12/27 14:49] – arnaud_poletto
+++ printer-setup [2022/01/10 14:56] (current) – removed arnaud_poletto
@@ Line 1: / Line 1: @@
-====== Printer Setup for stickers======
-===== Purpose and Scope =====
-This page describes the procedures for installing the printer and setting up the stickers to be printed.
-===== Prerequisite =====
-None
-===== Material =====
-  * A printer
-===== Printer Installation =====
-  - Make sure the printer contain power cable, USB cable and thermal label roll is installed.
-  - The thermal label roll to be used must be brother model DK-11209 with 62mm x 29mm.
-  - Connect the printer to computer using the USB cable.
-  - Connect the printer to power and turn it on.
-  - Download the windows Driver for the printer from https://support.brother.com/g/b/downloadtop.aspx?c=us&lang=en&prod=lpql1110nwbeus.
-  - After download, install it.
-  - The printer will be ready for use.
-===== Setting and Printing Stickers =====
-  - Login to your medAL-//data// server.
-  - Under ''Health Facility'', search the health facility for which you want to print label.
-  - Click on ''Stickers''.
-  - A popup will appear. Choose the number of stickers to generate.
-  - Click on ''Generate''.
-  - The pdf with the stickers will be generated.
-  - Do not print the stickers from the browser. Save the pdf at any location in your computer and open it with  //Adobe Reader// or //Adobe Acrobat//.
-  - Before printing, select ''Custom Scale'' and set to ''100%''.
-  - Also change the length units to ''mm'' and the sticker dimension to ''62mm x 29mm'' then print the stickers.
-  - Make sure the stickers are cut at the end (''Cut at end'' NOT ''Cut every'').
-  - Also print 2 copies.
-For any technical issues contact the Dynamic study IT Coordinators:
-  * Peter Agrea 0752665127, or
-  * Ibrahim Mtebene 0657181624