Differences

This shows you the differences between two versions of the page.

--- printer-setup [2021/12/27 14:40] – created arnaud_poletto
+++ printer-setup [2022/01/10 14:56] (current) – removed arnaud_poletto
@@ Line 1: / Line 1: @@
-====== Printer Setup for stickers======
-===== Purpose and Scope =====
-This page describes the procedures for installing the printer and setting up the stickers to be printed.
-===== Prerequisite =====
-:?:
-===== Material =====
-:?:
-===== Printer Installation =====
-  - Make sure the printer contain power cable, USB cable and thermal label roll is installed.
-  - The thermal label roll to be used must be brother model DK-11209 with 62mm x 29mm.
-  - Connect the printer to computer using the USB cable.
-  - Connect the printer to power and turn it on.
-  - Download the windows Driver for the printer from https://support.brother.com/g/b/downloadtop.aspx?c=us&lang=en&prod=lpql1110nwbeus.
-  - After download, install it.
-  - The printer will be ready for use.
-===== Setting and Printing Stickers =====
-•	Login Medial C system by using url https://medalc.unisante.ch/
-•	Under health facilities search the health facility for which you want to print label
-•	Click show and click Generate stickers.
-•	Within Generate stickers form select the study and write the number of stickers you want to print then click Generate
-•	The pdf with the stickers will be generated
-•	Do dot print the stickers from the browser, Save the pdf at any location in your computer and open it with  Adobe reader or adobe Acrobat
-•	Before print select “Custom Scale” and set to 100%
-•	Also change the length units to mm and the sticker dimension to 62mm x 29mm then print stickers (see the pictures below)
-•	Make sure stickers are cut at the end (“Cut at end” NOT “Cut every”)
-•	Also print 2 copies
-•	For any technical issues contact the Dynamic study IT Coordinators (Peter Agrea 0752665127 or Ibrahim Mtebene 0657181624)
-DELETEME
-== Credentials ==